Peerless-av WBK100-W - Installation Manuel d'utilisateur télécharger pdf (Page 2)

Visit the Peerless Web Site at www.peerlessmounts.com

2 of 3 ISSUED: 03-23-09 SHEET #:055-9262-1

Installation to Wood Stud Walls

Use a stud finder to locate the edges of the stud. Use of an edge-to-edge stud finder is highly recommended.

Based on its edges, draw a vertical line down the stud's center. Place wall plate (A) on wall as a template. Mark

the center of the four mounting holes. Drill four 5/32" (4 mm) dia. holes 2-1/2" (65 mm) deep. Secure wall plate

(A) to wood stud using four #14 x 2-1/2" wood screws (E) as shown. Skip to Step 3 of universal projector wall

arm.

• Installer must verify that the supporting surface will safely support the combined load of the equipment and all

attached hardware and components.

• Tighten wood screws so that wall plate is firmly attached, but do not overtighten. Overtightening can damage the

screws, greatly reducing their holding power.

• Never tighten in excess of 80 in. • lb (9 N.M.).

• Make sure that mounting screws are anchored into the center of the stud. The use of an "edge to edge" stud finder is

highly recommended.

• Hardware provided is for attachment of mount through standard thickness drywall or plaster into wood studs or joists.

Installers are responsible to provide hardware for other types of mounting situations.

WARNING

1 2 3

Pas de commentaire

Peerless-av WBK100-W - Installation Manuel d'utilisateur Page 2